 |
 |
 |
FloodStop™ Systems
see Our Search Feature - see Your Shopping Cart
see Many Other Products - see Customer's Testimonials - see Our FAQ's Page - see How to Order
With regular ground shipping we only charge 8% or less in the Contiguous U.S.! plus processing
see FlowManager - toilet overflow prevention kit
see shut off valve for washing machine -
see water alarms
"How does it work?"
Simple! You'll install a FloodStop motorized ball valve(s) upstream of each supply line and place our water sensor on the floor behind the unit that needs detection. If water leaks due to a broken line or the failure of ANY internal component of your plumbing fixture, the control unit tells the motorized ball valve(s) to shut off the water and sound an alarm.
"So these systems can prevent leaks or flooding?"
Yes they can; whether it's a small leak or large flood, FloodStops shut off the water at the appliance. They protect against broken lines, bursting lines and failure of internal components of your plumbing fixture.
"If there is no electricity running to the valve (either because they haven't been hooked up or the sensor has touched water), are the valves normally open or closed?"
In their normal position, the FloodStop valves are open and will allow water to pass through; once water touches their sensor, the motorized ball valve is tripped and the valves are closed. The valve(s) will remain closed until the sensors are dried and the reset "Open" button is pressed. The Controller has a battery port for 4 X C size batteries, which will serve as a battery backup in case of a power outage. The same batteries will serve as the primary power source if a nearby electrical outlet is not available (battery life 1 year).
"Does the FloodStop system shut off water to the whole house?"
No, this is a point of use product; it only shuts the water off at the source of the leak. Why shut off the water to your whole house if the cause of the problem is just at the washing machine, for instance? Whole house systems are much more expensive and usually require a plumber to install.
"What should I do after the system has detected a leak?"
If a leak has occurred, turn the manual valve(s) to the off position, investigate and repair/stop the leak, dry the sensor, and reset the controller by pressing the "Open" button.
"Are FloodStop systems difficult to install?"
No, if you can install a garden hose, you can install FloodStop. Installation takes 5 to 10 minutes, and your home will be protected against many sources of water damage.
"Why would I need to use the transformer extension wire?"
Unlike the washing machine and the icemaker, the water heater is not always located next to an electrical outlet, and so you may need to use the 15-foot-long low-voltage extension wire.
"Why would I need an additional sensor?"
You can increase your area of protection by adding extra sensors near your fixtures, such as behind your dryer or laundry tray/sink. Additional sensors can also be placed in your water heater's drain pan, as well as on the floor nearby (in case a leak sprays outside the pan); also, you may choose to install a sensor under your icemaker valve, another behind the refrigerator and a third near your icemaker's filter (if you have one).
"What about braided hoses, aren't they burst proof?"
You should use braided hoses whenever you can (especially on your washing machine), and take every precaution to avoid water damage, but hoses are not the only source of flooding. And, braided hoses are not burst proof, but only burst resistant. There are a wide variety of clamps, valves, pumps, drains, etc. inside many fixtures that can fail. (FloodStop was designed after the inventor suffered a home flood due to a switch failure that did not tell his washing machine when to stop filling with water. Water continued to run into the washer and flooded the house for 3 hours before it was discovered.)
at THE PlumbingWorld, we offer thousands of plumbing products and more: